Insert this bracket into your 2" hitch receiver to mount your Lock 'N' Roll vehicle-side hitch or a different adjustable-height coupler. 3-Position channel lets you move hitch or coupler up or down to match your trailer's height.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello, everybody, this is Jeff at etrailer.com. Today we're gonna take a look at this Lock N Roll Extended Shank Three Position Adjustable Channel Bracket for two-inch hitch receivers. Has a 4,500 pound weight capacity. Now, basically you'll insert this bracket into your two-inch hitch receiver to mount your Lock N Roll Articulating Hitch or a different adjustable height coupler to your vehicle. The extended shank, right here, slides into a two inch hitch receiver opening and secures with a pin and clip which is sold separately. The hitch pin hole diameter is five eights of an inch.
So if you need a pin and clip for this, we do sell those separately or if you already have a pin and clip that's five eights of an inch diameter, you could use that. Now, this shank will extend out from the center of the hitch pinhole to the center of these adjustment holes, 13 and three quarter inches and that extended shank allows you to clear the spare tire on Jeeps and SUVs. Now, this channel bracket itself has three different mounting positions for connecting your Adjustable Channel Mount Lock N Roll Articulating Hitch which we sell separate on our website. It's part number 336VS503 and it can also be used to mount any coupler that'll fit into a three inch wide channel and in two inches between the adjustment holes. The three position adjustment channel will let you move your hitch or your coupler up or down and match your trailer's height.
The hitch slides up or down the bracket and it'll secure with five eight inch diameter pins and clip to also, which we do sell separately. Now, the whole spacing we mentioned between the adjustment holes is two inches center to center. This part is a steel alloy construction, it's very strong and durable. You can see it has a nice black paint finish to it to resist corrosion. It is made in the USA.
The application, again, fits two inch by two inch trailer hitch receivers. Maximum gross trailer weight capacity, 4,500 pounds. Maximum tongue weight capacity, 450 pounds. Last thing I'm gonna do is just give you some measurements on the channel itself. The height on it, seven and a half inches tall and the width of it, which is always measured inside to inside, right at three inches wide.
But that should do it for the review on the Lock N Roll Extended Shank Three Position Adjustable Channel Bracket for two inch hitch receivers.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.